4. Tiger Teeth Traffic Controllers - Motorized - Surface Mounted
Motorized Traffic control products are ideal for controlling most one way traffic. The traffic control spike set will allow vehicular traffic travel in one direction only.
Motorized Tiger Teeth - Surface Mounted
The Automated / Hydraulic, surface mount traffic controller is designed to regulate the flow of traffic through a secured control point, while providing both a physical and visual barrier to approaching vehicles and preventing against unauthorized vehicles from either entering or exiting a secured control point.
Hydraulic Control Unit : Provides weather and antivandal protection
Tunnel Section : Standard 36 inch modules. Can be sized as required.
Traffic Control Modules : Lengths 36 inches, up to a maximum of 8 modules (24 feet) of control modules can be driven form a single hydraulic control unit .
Operating Time : Cycle to lower teeth 1 second, Cycle to raise teeth 1 second
Drive Configuration : Hydraulic power unit.
Power Requirements : ½ HP, 110V Single-phase 7A. The unit can be built to meet any local power requirement as to voltage, frequency and phase.
Finish : Epoxy urethane enamel (Red or Yellow)
Control Circuit : The machine is completely pre-wired requiring only the connection of the power feed and the control circuits. The circuits and power connections are terminated at the wire connector strips in the electrical control box located in the locked hydraulic control cabinet. The controls are pre-wired to accommodate a wide range of control options including: remote open and close from multiple locations; radio open and close; open by card reader, key switch or vehicle detector.
Documentation : Each machine is furnished with the following, Mechanical Installation Instructions, Electrical & Control Installation, Start Up Procedures, Trouble Shooting, Electrical, Mechanical Drawings
Options : Stop-Go Signal, Radio Receiver, Remote Radio Control, High Security Card Readers, Key, Battery Backup.
Shipping Weight : This machine is modularized for ease of shipping and handling.
Motorized Tiger Teeth - Surface Mounted
click for larger view
| Hydraulic Control Cabinet |
175 lbs. |
| Drive Tunnel 36.0 inches |
175 lbs. |
| Control Ramps 36.0 inches |
220 lbs. |
Click Here to Download Tiger teeth Motorized Above Ground Specs and graphics
*Kit is One Motor, 3 feet of tunnel, plus 6 foot Tiger Teeth, plus one guard button
►
Click here if you need Security Booths or kiosks |
Surface mount for rapid installation and speed bump effect. )
)
)
)
)
)
©2005 Control
Electronic Security and its licensors. All rights reserved.){kind=link}
){kind=link}
){kind=link}